 |
|
 |
|
 |
| |
Development Tools
- AM100 Buffer IP Accessory: (from C&H Technologies)
- Buffer IP Accessory, dual output signal buffering for other C&H IP source modules, 300ma drive.
- AM101 IP Extender/Breakout Board: (from C&H Technologies)
- IP Extender/Breakout Boards, AM101-1 locks IP at a right-angle to carrier with IP interface signal breakout pins for attachment to analyzers and scopes. AM101-2 provides signal breakout of all IP I/O signals. Single wide allowing multiple instances on carrier.
- HDRribn50: (from Dynamic Engineering)
- 50 pin Ribbon cable with pull tabs and strain relief.
Multiple lengths and styles available
- HDRribn50: (from Dynamic Engineering)
- 50 pin Ribbon cable with pull tabs and strain relief.
Multiple lengths and styles available
- HDRterm50 terminal board: (from Dynamic Engineering)
- HDRterm50 will make your IndustryPack system inter-connection easier providing an interconnection method between 50 pin ribbon cable and discrete wiring systems.
- IP Engineering Kit: (from Dynamic Engineering)
- Engineering Kits are available for all Industry Pack module(s). The kits include: Board level Schematics [PDF], Reference Software [PCI3IP, WIN NT, WinRT, Visual C ZIP file], IP-DEBUG-BUS, IP-DEBUG-IO.
- IP-BusProbe: (from SBS Technologies)
- IndustryPack Diagnostics, Extender board enables the diagnostics of an IP, allows connection of a logic analyzer or an oscilloscope, support double-wide and 32MHz IPs.
- IP-DEBUG-BUS: (from Dynamic Engineering)
- Gain access to all of the IndustryPack Bus signals with the IP-Debug-Bus. IP-Debug-Bus is a specialized extender card optimized for testing IP Modules. The bus signals are accessible via test points. The testpoints include multiple ground locations and .025 sq. posts. Power is controlled with an on-board switch to allow the IP Module to be powered down without turning off the host system. The logic signals are automatically isolated with 'quick switch' technology. LEDs indicate when power is applied. 'Self healing' fuses are provided for power protection.
- IP-DEBUG-IO: (from Dynamic Engineering)
- The IP-DEBUG-IO II is designed to allow test circuits to be added to simulate part of the system that may not be available. Test points are provided on each of the 50 IO lines. PC style power connector and matching 4 pin header for easy connection to a power supply. PLCC 28, oscillator and SO 8 positions provided.
The IP-DEBUG-IO II has two 50 pin header connectors provided to allow connection to your system while debugging the IP or adding testpoints to a system cable.
- IP-Design Kit: (from SBS Technologies)
- IndustryPack Design Kit, Prototype module includes two flex cables, IP Spec, IP interface logic, double-wide, holds 100 ICs.
|
|
|
|
|
|
